I just reset my Panasonic A110 to factory settings.Can not find my owners manual,and need to set my audio out setting for the DVD player. I don't remember what they were.My DVD player is connected to the receiver with optical cable.The receiver decodes DD and DTS.The following are my choices via the DVD players menue.

LPCM (DVD)- off or pcm
Dolby Digital- pcm or bitstream
DTS- off or bitstream

Thanks Jim

Leave PCM off and turn Dolby Digital and DTS to bitstream.

------------------
Dave My DVDs(Not updated anymore since DVD Tracker uncooly started charging). My Humble Home Theatre

Thanks for the reply.That is what I have them set at.Just wanted to be sure they were right.What is LPCM used for anyway?

Jim

[This message has been edited by Jetfan (edited November 12, 2000).]

PCM is an uncompressed digital stereo signal. It transfers at approx. 1.4Mbps, more than a full-rate DTS signal. It gives very good sound. I forget what L stands for though.

I beleive it's Linear Pulse Code Modulation. http://talk.dvdtalk.com/ubb/smile.gif http://talk.dvdtalk.com/ubb/biggrin.gif

------------------
MY SHORT BUT SLOWLY EXPANDING DVD LIST


MY GETTING LONGER BUT SLOWLY EXPANDING DVD LIST

"The earth does not belong to people; people belong to the earth. Everything that happens to the earth happens also to the sons and daughters of the earth." -Chief Seattle.