Component inputs needed to enjoy anamorphic DVD's?
 

I recently acquired a receiver and will soon begin using that to switch between my video sources. Since it only switches S-Video I would have to give up my component connection from my DVD player to the TV.

Will I still be able to enjoy anamorphic DVD's using the S-Video cables?

<small>I know I could still plug the DVD player directly to the TV and just route the sound through the receiver, but I'm trying to keep the wiring simple. My wife is going to have to use the system, too.</small>

Re: Component inputs needed to enjoy anamorphic DVD's?
 

Yes.

Re: Re: Component inputs needed to enjoy anamorphic DVD's?
 

Thanks.

<small>That was fast.</small>

Heck, while we're at it (and for informational purposes) can one enjoy anamorphic DVD's (and their increased resolution) using composite connections?

Anamorphic is related to the way the DVD was created (and how it interacts with your DVD player) and not really related to the output of the DVD player. No matter what type of connection you use, the output is still the same - you'll get a 480i image.

Progressive signals though do require the use of component cables and a compatible TV set.

Has anyone upgraded to progressive scan and actually noticed a significant improvement? It is a difference only the trained eye can detect?

Progressive scan's improvement depends a lot on the video display used. A 32" HDTV will show a much smaller improvement then a 100" front projection system. Often the difference is barely noticeable until you get used to prog scan and try and switch back to an interlaced picture. Then you realize how good you had it.

Another thing to consider. Progressive scan will make bad transfers look worse. Bottom line, a reference DVD should look better by a small but noticeable amount.